Merge branch 'master' of https://bitbucket.itg.ti.com/scm/mitl/mmwave_ti_ros

autonomous_robotics_ros/docs/common/ROS Setup for Autonomous mmWave.html

@@ -33,19 +33,15 @@ This will enable users to gain familiarity with the sensor's capabilities as wel
 
 #### ISK EVM  
   
+The following ISK modules are compatible. Only one of the following is required for this lab.
+
 Quantity          | Item    
 ------------------|-----------------  
  1 or 4        | Antenna Module Board: [IWR6843ISK](http://www.ti.com/tool/IWR6843ISK)
-
-  
-OR
- 
-#### AOP EVM  
-
- Quantity          | Item    
-------------------|-----------------
+ 1 or 4        | Antenna Module Board: [IWR1843BOOST](http://www.ti.com/tool/IWR6843ISK)
  1 or 4       | [IWR6843AOPEVM](http://www.ti.com/tool/IWR6843AOPEVM)
  
+
  [[r! IWR6843 ES2.0 Only
  This lab is only compatible with ES2.0 version of IWR6843. 
  
@@ -225,20 +221,21 @@ and re-open the shell for the updated **~/.bashrc** file to take effect.
 1. The packages for all ROS labs are held on git.ti.com. To download the packages, first ensure that git is installed on your computer. 
 
   ```
-  sudo apt-get install git
+  $ sudo apt install git
   ```
 
 2. Next, download the repository to the user's home directory. Skip this step if the git repository has already been cloned. 
 
   ```
-  cd ~ && git clone git.ti.com/
+  $ cd ~ 
+  $ git clone https://git.ti.com/git/mmwave_radar/mmwave_ti_ros.git
   ```
 
 3. Change directory to the autonomous_robotics_ros folder. The safety bubble lab is included in the same folder. 
 
-    ```
-    cd mmwave_ti_ros/autonomous_robotics_ros/
-    ```
+  ```
+  $ cd mmwave_ti_ros/autonomous_robotics_ros/
+  ```
 
 3. Build the lab.
   ```

autonomous_robotics_ros/docs/safety_bubble/Safety_Bubble_with_ROS_for_mmWave_user_guide.html

@@ -52,7 +52,7 @@ Here are the steps to run the sensor bubble demo.
   ```
 
 2. SSH into the remote laptop, and run the following. If the EVM was not in a good state the roslaunch command will fail. Try resetting the EVM by
-pressing the ‘NRST’ button on the EVM and then run the desired roslaunch command again. The `<device>` tag noted below can be one of the following: `6843ISK` or `6843AOP`.
+pressing the ‘NRST’ button on the EVM and then run the desired roslaunch command again. The `<device>` tag noted below can be one of the following: `6843ISK`, `6843AOP`, or '1843'.
   
   ```
   $ roslaunch ti_mmwave_rospkg bubble_sensor_north.launch config:=3d device:=<device>