previously, get_devname() was used as the I2C device path, but on NuttX,
get_devname() is the device file which the driver creates. This patch
changes it, so the sematics are the same as on NuttX: both now use _bus
to decide to which I2C bus device to talk to.
I did not see any other use-cases than the led on ocpoc.
These functions used vprintf which is not available on all platforms.
They also do not enable line and file debug output.
Changed to macros that preserve the output format. Uses new macro that
can be used to implement per object, runtime selectable logging
Signed-off-by: Mark Charlebois <charlebm@gmail.com>
The baro was not fully initialized when the sensors module tried to
open it. Added a sleep command and a sleep 2 to rc.S so the baro
is initialized by the time the sensors module tried to read it.
Fixed other noisy errors
Signed-off-by: Mark Charlebois <charlebm@gmail.com>
This adds support for a dynamic build for QuRT and initial
Multi-uORB changes to enable communication between the DSP and
the application processor.
This part of the changes do not affect the POSIX build. This is
enablement for the QuRT build using Multi-uORB. The second part
of the changes will be added in a new module under src/modules.
Signed-off-by: Mark Charlebois <charlebm@gmail.com>
The debug message made it difficult to use the shell for the
posix build. Commented out the debug line.
Signed-off-by: Mark Charlebois <charlebm@gmail.com>
Changed "linux" target to "posix". Most of the changes are shared with
QuRT and with OSX. The Linux specific parts are in for i2c which uses
<linux/i2c.h> and <linux/i2c-dev.h>.
There is also a check for __PX4_LINUX in mavlink for a tty ioctl that is
not supported.
Signed-off-by: Mark Charlebois <charlebm@gmail.com>
