- implement COMP_METADATA_TYPE_VERSION & add component_version.json.gz to
ROMFS for all targets.
- implement COMP_METADATA_TYPE_PARAMETER (only enabled for SITL currently)
* MC_HTE: unitialize with hover_thrust parameter
* MC_HTE: constrain hover thrust setter between 0.1 and 0.9
* MC_HTE: integrate with land detector and velocity controller
* MCHoverThrustEstimator: Always publish an estimate even when not fusing measurements. This is required as the land detector and the position controller need to receive a hover thrust value.
* MC_HTE: use altitude agl threshold to start the estimator
local_position.z is relative to the origin of the EKF while dist_bottom
is above ground
Co-authored-by: bresch <brescianimathieu@gmail.com>
with measurement noise auto-tuning
The purpose of this estimator is to improve land detection and vertical
velocity feedforward
Recovery strategy:
This is required when the setpoint suddenly changes in air or that the
EKF is diverging. A lowpassed test ratio is used as a trigger for the recovery logic
Also, a lowpassed residual is used to estimate the steady-state value
and remove it when estimating the accel noise to avoid increasing the
accel noise when the redisual is caused by an offset.
This validator takes measurements from a single airspeed sensor and:
-checks validity of measurement
-can estimate an airspeed scale factor (estimation enabled with parameter setting) to accout for errors in airspeed due due placement of sensor
Signed-off-by: Silvan Fuhrer <silvan@auterion.com>
This moves the hysteresis test out of the systemlib and makes it its own
small library. Since it still depends on hrt_absolute_time this does not
link yet. My attempt to get all link dependencies together failed.
