This is done to allow proper initialization of the new FlightTask and
give it a chance to continue the setpoints without discontinuity. The
function checkSetpoints replaces the setpoints containing NANs with an
estimate of the state. The estimate is usually the current estimate of
the EKF or zero.
The transition FlightTask also provides an estimate of the current
acceleration to properly initialize the next FlightTask after
back-transition. This avoid having to initialize the accelerations to
zero knowing that the actual acceleration is usually far from zero.
the vehicle yaws towards the next waypoint before accelerating. This is
required for drones with front vision and aerodynamic multicopters such
as standard vtol planes or highspeed multirotors.
The initial idea of the flight task architecture was that
a task can freely set it's setpoints and doesn't have to
worry about takeoff and landing. It would just takeoff
when it's landed and there's a setpoint to go up and
land when it puts a setpoint that pushes into the ground.
With the takeoff logic there are some significant interface
problems depending on the way a task is implemented:
From the setpoint is not high enough to trigger to
an unexpected takeoff because of some estimator
fluctuation affecting the setpoint. It's easiest to solve this
by allowing the task to determine when a takeoff is triggered.
If no condition is implemented by default a task is not
allowing a takeoff and cannot be used to get the vehicle
off the ground.
