Fixed UAVCAN146 linker script that caused CXX initalization to wrong
Enabled uORB listener command
Updated UAVCANv1 msg definition
Known isssue: PX4 params are not working on the UAVCAN146
- same pattern as other new drivers (state machine, checked register mechanism, no sleeps, etc)
- self test has been rolled into regular startup sequence
- still I2C only, but will be expanded in the future
- configure to high accuracy preset
- currently the main change is that it reduces the max number of ORB multi instances to 4, but usage will be expanded as needed
- limits number of EKF2 multi instances to 2.
- enabled on all cortex m4 boards
This system command will display, set and save the network
settings.
netman show - Displays the current settings.
netman update - Will check for a net.cfg file on the SD card.
If present, it will update the paramaters,
delete the file, and reboot. Using the new settings.
netman save - Saves the current settings to net.cfg on the SD card.
This file shoulf be renamed to preserver it across
reboots or editited to chech networkin paramates.
File format is name<space>value:
echo DEVICE=eth0 > /fs/microsd/net.cfg
echo BOOTPROTO=fallback >> /fs/microsd/net.cfg
echo IPADDR=192.168.0.4 >> /fs/microsd/net.cfg
echo NETMASK=255.255.255.0 >>/fs/microsd/net.cfg
echo ROUTER=192.168.0.254 >>/fs/microsd/net.cfg
echo DNS=192.168.0.254 >>/fs/microsd/net.cfg
Valid values for `proto` are `dhcp`, `static`, `falback`
Both will try dhcp for CONFIG_NETINIT_FALLBACK times
and fall back to the static address.
NETMASK - is the network mask.
IPADDR - this nodes ip address for static or fall back.
ROUTER - The default route.
DNS - The address of the dns server.
- generate PWM_MAIN 1-14
- generate PWM_AUX 1-8
- generate PWM_EXTRA 1-8
- px4io and pwm_out directly read configuration parameters
- only available and active physical outputs are actually shown for configuration
- overall saves flash despite adding many new parameters
This fixes RSSI for the Control Zero F7 but I have noticed that while this works perfectly for SBUS receivers, for PPM receivers it does not decrease the RSSI visual value in QGC when removing the RC transmitter connection.
When a PPM receiver is connected and the connection is lost the autopilot goes into RC Scan Mode (in the RC Update Module) to determine what is connected (even though something already is connected).
The main issue with this is that PPM receivers don't go into RC Failsafe but I don't think it is an issue with this autopilot. It looks to be an issue with the RC Update Module and how it is handled at the module level for non I/O coprocessor autopilots.
Tested with an X8R (SBUS) and a Dragonlink (PPM) as well as a Dragonlink set to SBUS as the output. SBUS worked as intended. See screenshots below.
