- this is a new module for temperature compensation that consolidates the functionality previously handled in the sensors module (calculating runtime thermal corrections) and the events module (online thermal calibration)
- by collecting this functionality into a single module we can optionally disable it on systems where it's not used and save some flash (if disabled at build time) or memory (disabled at run time)
* parameter and logic to commander for triggering failsafe from external automatic trigger system.
* logic to startup script for enabling ATS. Added uORB publishing to pwm_input module.
* Refactored out CDev usage from pwm_input and ll40ls. Refactored out ll40ls specifics from pwm_input and cleaned up dead code.
This target was never fully supported and is heavily dependent on a number of DriverFramework drivers that have no in tree equivalents (bebop bus, flow, rangefinder, etc). Deleting this will make it easier to fully drop DriverFramework shortly.
When running in HITL mode, pwm_out_sim publishes actuator_outputs.
px4io unconditionally publishes the uOrb actuator_outputs. When HITL
is configured, the px4io copy of the uOrb has all zeros.
The result is that there are two publications, one valid, and one
all-zeros. This causes the HIL_ACTUATOR_CONTROLS mavlink message
to be incorrect (all-zeros) and the SERVO_OUTPUTS_RAW mavlink
message to be inconsistent, as it takes the data from one or the
other uOrb randomly each cycle.
The fix is to let px4io know that HITL is in effect when it is
started, and modify px4io to suppress publication in this case.
This is a bigger more complicated fix than I would like, but I
think it is conceptually correct.
Signed-off-by: Nik Langrind <langrind@gmail.com>
* Draco-R sensor orientation correction
* LL40LS sensor is not stable during I2C probing. More trials have been implemented.
* px4flow execution has been removed as rc script already running it
* GPS LED script repaired
* Off ICM20608 due to some bug?
* Removed i2c speed adjustment due to SMBUS.
* ms5611 test2 does not exist
* Baud rate has changed.
* Draco-R airframe parameters are updated.
* IFO and Draco parameters are updated
* Draco-R sensor orientation corrected
* Draco-R DSHOT supports
-moved rc.mavlink to the boards optional rc additions (now it's called rc.board_mavlink) to handle board specific mavlink needs (mavlink over usb, ethernet, additional streams, etc.)
-mavlink module will be responsible to usb defaults, therefore less args are needed to be passed to mavlink module if one wants to use mavlink over usb.
-the way to check if connection is usb is by it's designated variable and not by config mode.
This change adds the line "param set RTL_TYPE 1" to the default init scripts for fixed wing. Similar to the other PR that sets default RTL_TYPE=1 for VTOLs, RTL_TYPE=1 should be default for normal fixed wings as well. Reference: https://github.com/PX4/Firmware/pull/12746/files
This new airspeed module does:
-runns an airspeed validator for every airspeed sensor present, which checks measurement validity and estimates an airspeed scale
-selects another airspeed sensor if for the current one a failure is detected
-estimates airspeed with groundspeed-windspeed if no valid airspeed sensor is present
-outputs airspeed_validated topic
Signed-off-by: Silvan Fuhrer <silvan@auterion.com>
