The baro was not fully initialized when the sensors module tried to
open it. Added a sleep command and a sleep 2 to rc.S so the baro
is initialized by the time the sensors module tried to read it.
Fixed other noisy errors
Signed-off-by: Mark Charlebois <charlebm@gmail.com>
There is a race condition for the accel and mag polling rates.
Whichever one gets set first, the other will be uninitialized.
Set the mag polling rate to 1ms if uninitilized.
Signed-off-by: Mark Charlebois <charlebm@gmail.com>
The workqueues measure time in ticks which is typically 10ms.
Some interrupt events in Nuttx occur at about 1ms so a more
granular workqueue is needed for POSIX.
Signed-off-by: Mark Charlebois <charlebm@gmail.com>
The existing orb_advert_t use thoughout the code sometimes tries
to treat it as a file descriptor and there are checks for < 0
and ::close calls on orb_advert_t types which is an invalid use
of an object pointer, which is what orb_advert_t really is.
Initially I had changed the -1 initializations to 0 but it was
suggested that this should be nullptr. That was a good recommendation
but the definition of orb_advert_t had to change to void * because
you cannot initialize a uintptr_t as nullptr.
Signed-off-by: Mark Charlebois <charlebm@gmail.com>
The calls to orb_advertise were being mishandled throughout the code.
There were ::close() calls on memory pointers, there were checks
against < 0 when it is a pointer to a object and values larger than
0x7ffffffff are valid. Some places orb_advert_t variables were
being initialized as 0 other places as -1.
The orb_advert_t type was changed to uintptr_t so the pointer value
would not be wrapped as a negative number. This was causing a failure
on ARM.
Tests for < 0 were changed to == 0 since a null pointer is the valid
representation for error, or uninitialized.
Signed-off-by: Mark Charlebois <charlebm@gmail.com>
The warnx and warn calls map to PX4_WARN.
Calls to errx or err genrtate a compile error.
The px4_log.h file implements a new log format:
For DEBUG and INFO:
<level> <msg>
For ERROR and WARN:
<level> <msg> (file filepath line linenum)
The verbosity can be changed by setting the macro to use
either linux_log or linux_log_verbose in px4_log.h
Signed-off-by: Mark Charlebois <charlebm@gmail.com>
Created px4_debug,h to define:
PX4_DBG
PX4_INFO
PX4_WARN
PX4_ERR
These enable OS specific mappings to be made, filtering, etc.
Signed-off-by: Mark Charlebois <charlebm@gmail.com>
To facilitate testing, the simulated devices always return OK for
self tests.
rc.S was also upated to set CAL_XXXY_ID to the devid so tests pass the
calibration check.
Signed-off-by: Mark Charlebois <charlebm@gmail.com>
Changed "linux" target to "posix". Most of the changes are shared with
QuRT and with OSX. The Linux specific parts are in for i2c which uses
<linux/i2c.h> and <linux/i2c-dev.h>.
There is also a check for __PX4_LINUX in mavlink for a tty ioctl that is
not supported.
Signed-off-by: Mark Charlebois <charlebm@gmail.com>
