boards/nxp/fmuk66-v3/init/rc.board_sensors

#!/bin/sh
#
# NXP fmuk66-v3 specific board defaults
#------------------------------------------------------------------------------

board_adc start

# Internal Mag I2C bus roll 180, yaw 90
bmm150 -I -R 10 start

# Onboard I2C baros
bmp280 -I start
mpl3115a2 -I start

# Internal SPI (accel + mag)
fxos8701cq -s start

# Internal SPI (gyro)
fxas21002c -s start
ROMFS split rc.board into defaults, sensors, and extras 2018-12-14 12:36:32 -05:00			`#!/bin/sh`
			`#`
			`# NXP fmuk66-v3 specific board defaults`
			`#------------------------------------------------------------------------------`

Rename and move src/drivers/adc to src/drivers/adc/board_adc 2020-09-08 11:09:20 +08:00			`board_adc start`
ROMFS split rc.board into defaults, sensors, and extras 2018-12-14 12:36:32 -05:00
nxp_fmuk66-v3:Set bmm150 orientation 2019-03-08 14:13:10 -08:00			`# Internal Mag I2C bus roll 180, yaw 90`
refactor bmm150: use driver base class 2020-03-11 18:56:46 +01:00			`bmm150 -I -R 10 start`
[Breaking Change]fmuk66-v3: Only Support Rev BX11 I2C bus chaged I2C0 is external, I2C1 internal Added BMM150 on I2C1 @ Addr 0x100 Added BMP280 on I2C1 @ Addr 0x76 UART0 (/dev/ttyS1) now used at Telem 2 Chip select added for W25X40CLUXIG Calibration EE prom Driver is not added at this time 2019-01-22 04:49:43 -08:00
			`# Onboard I2C baros`
			`bmp280 -I start`
			`mpl3115a2 -I start`
ROMFS split rc.board into defaults, sensors, and extras 2018-12-14 12:36:32 -05:00
			`# Internal SPI (accel + mag)`
refactor fxos8701cq: use driver base class 2020-03-23 11:21:37 +01:00			`fxos8701cq -s start`
ROMFS split rc.board into defaults, sensors, and extras 2018-12-14 12:36:32 -05:00
			`# Internal SPI (gyro)`
refactor fxas21002c: use driver base class 2020-03-23 11:21:16 +01:00			`fxas21002c -s start`